Ironworker Pro 4.1

Every chart you need on the iron. In your pocket.

IronWorker Pro is the field reference built by a working structural ironworker, not a software company. Weld symbols and settings, rigging and fall clearance, steel and bolt charts, a feet-inch calculator, animated guides and now Cut Pro. Almost all of it works with no signal on the deck.

CUT PRO: CUT STEEL, WASTE LESS
Type in your sticks and plate parts. Cut Pro works out the fewest pieces to buy, uses your rack drops first, and draws a cut sheet for every stick and every sheet of plate. Then it builds one clean material order, with sizes, lengths, grades and weights, that you can email or text straight to your supplier.

WELDING

Weld symbols: read any callout, fillet, groove and supplementary symbols
Weld Setting Wizard and Settings Chart: amps and volts by process and thickness
NEW: NR-232 field wire settings for .068, .072 and 5/64, from Lincoln’s data sheet
Fillet weld and heat input calculators, preheat lookup, electrode and gas guides
Weld defects, CJP and backgouge, rebar weld sizes, stud welding, test prep

RIGGING & SAFETY

Sling angle calculator: real tension in every leg
Lift plan, rigging hardware, crane hand signals and load charts
Fall clearance with free-fall warnings
Pre-lift, fall protection and hot work checklists that sign off to your Job Log

STEEL & LAYOUT

Beam, channel, angle, HSS and pipe shapes and weights
Bolts, edge distance, torque and turn-of-nut
Pipe handrail and rails, copes and hole layout, deck and stud estimates

A CALCULATOR THAT READS LIKE YOUR TAPE
Feet, inches and 16ths. Every length also shows on a tape blade so you know exactly which tick to pull to. Equal Spacing gives every running mark, Arc Radius works off a chord and rise, Bolt Circle gives X/Y for every hole. Plus rise-run-diagonal, stairs, plate weight and trig. Your tape history saves.

SEE IT, DON’T JUST READ IT
23 animated guides grouped into Weld, Quality, Cut, Rig and Erect, including weld positions in 3D.

YOUR RECORDS

Job Log with photos and photo markup, and an hours tracker
NEW: Notes and punch lists with colors, folders, pins and checklists
Free account: back up your log, photos, hours and notes and restore them on a new phone. Notes sync with ironworkerpro.com.
Bought the app? Sign in and Pro Tools on ironworkerpro.com unlocks with the same account.

MADE FOR THE JOB

Big glove-friendly buttons and Glove Mode
7 themes plus the new Liquid Glass look
No ads

DISCLAIMER
IronWorker Pro is a reference and training aid. It does not replace your training, a competent or qualified person, or the job’s documents. The approved drawings, specifications, your WPS, the lift plan, the manufacturer’s instructions, applicable codes (such as AWS, ASME, RCSC and OSHA) and your site safety rules always govern. Weld settings are typical starting points, rigging numbers are estimates, and Cut Pro and calculator results are only as good as what you enter. Check every cut, measurement, weld and pick before you act on it. The full disclaimer and sources are in the app under Settings › Disclaimer & Sources and at ironworkerpro.com/disclaimer.

Built on the iron, for the iron.

License: Commercial